44
EN
Error Messages
Symptoms Reason Solution
Water supply is not adequate in area. • Check another tap in the house.
Water supply taps are not completely
open.
• Fully open tap.
Water supply hose(s) are kinked. • Straighten hose(s).
The lter of the supply hose(s) are
clogged.
• Check the lter of the supply hose.
If water leakage occurred in the aqua
stop supply hose, indicator
will
become red.
May vary depending on the model.
• Use the aqua stop supply hose.
Load is too small.
• Add 1 or 2 similar items to help balance
the load.
Load is out of balance.
• Add 1 or 2 similar items to help balance
the load.
The appliance has an imbalance
detection and correction system. If
individual heavy articles are loaded
(e.g. bath mat, bath robe, etc.) this
system may stop spinning or even
interrupt the spin cycle altogether.
• Rearrange load to allow proper
spinning.
If the laundry is still too wet at the end
of the cycle, add smaller articles of
laundry to balance the load and repeat
the spin cycle.
• Rearrange load to allow proper
spinning.
To Next Page
Loading...
Need help?
General
