16
INSTALLATION
EN
• The appliance must be 100%
hori
zontal and stand firmly in positi
on
on a hard flat floor.
•
It must not ‘Seesaw’ across corn
ers
under
the load.
•
Do not let the feet of the
appliance get
wet.
Failure to do so may ca
use
vibration or noise.
Using Anti-Slip Sheets
This feature may vary depending on the
model purchased.
If you install the appliance on a slippery
surface, it may move because of
excessive vibration. Incorrect levelling
may cause malfunction through noise
and vibration. If this occurs, install the
anti-slip sheets under the levelling feet
and adjust the level.
1
Clean the floor to attach the anti-slip
sheets.
•
Use a dry rag to remove and clean
foreign objects and moisture
. If
mo
isture remains, the a
nti-slip
s
heets may slip.
2
Adjust the level after placing the
appliance in the installation area.
3
Place the adhesive side
a
of the anti-
slip sheets on the floor.
•
The most effective way is to in
stall
the anti-sl
ip sheets under the front
feet. If it is difficult to place the
sheets u
nder the front feet of the
appliance, attach them under the
rear feet.
4
Put the appliance on the anti-slip
sheets.
•
Do not attach the adhesive side
a
of anti
-slip sheets to the feet of the
appliance.
• Additional anti-slip sheets are available
at LG Electronics service centre.
Connecting the Water
Supply Hose
Note for Connection
• Water pressure must be between
100
kPa
and
1000 kPa
(1.0‒10.0 kgf/cm²).
If the wa
ter pressure is more than
1000 kPa
, a decompression device
sh
ould be installed.
•
Periodically check the condition of the
water supply hose and replace the
w
ater supply hose if necessary.
• Do not overtighten the water supply
hose or use mechanical
devices to
tighten onto the inlet valves.
To Next Page
Loading...
Need help?
General
