38
ENG
ENGLISH
SETTINGS / TO SEE WEB MANUAL / EXTERNAL CONTROL DEVICE SETUP
Supported Audio Formats
File type : mp3
[Bit rate] 32 Kbps - 320 Kbps
[Sample freq.] 16 kHz - 48 kHz
[Support] MPEG1, MPEG2, Layer2, Layer3
File Type : AAC
[Bit rate] Free Format
[Sample freq.] 8 kHz ~ 48 kHz
[Support] ADIF, ADTS
File Type : M4A
[Bit rate] Free Format
[Sample freq.] 8 kHz ~ 48 kHz
[Support] MPEG-4
File Type : WMA
[Bit rate] 128 Kbps ~ 320 Kbps
[Sample freq.] 8 kHz ~ 48 kHz
[Support] WMA7, WMA8, WMA9 Standard
File Type : WMA
[Bit rate] ~ 768 Kbps
[Channel / Sample freq.]
M0 : up to 2 Channel @ 48 kHz
(Except LBR mode),
M1 : up to 5.1 Channel @ 48 kHz,
M2 : up to 5.1 Channel @ 96 kHz
[Support] WMA 10 Pro
File Type : OGG
[Bit rate] Free Format
[Sample freq.] ~ 48 kHz
[Support] OGG Vorvis
Supported Photo Formats
Category : 2D (jpeg, jpg, jpe)
[Available le type] SOF0: Baseline,
SOF1 : Extend Sequential,
SOF2 : Progressive
[Photo size] Minimum : 64 x 64,
Maximum : Normal Type: 15360 (W) x 8640
(H), Progressive Type : 1920 (W) x 1440 (H)
Category : BMP
[Photo size] Minimum : 64 x 64, Maximum :
9600 x 6400
Category : PNG
[Available le type] Interlace, Non-Interlace
[Photo size] Minimum : 64 x 64, Maximum :
Interlace : 1200 x 800, Non-Interlace : 9600
x 6400
BMP and PNG format les may be slower to
display than JPEG.
TO SEE WEB MANUAL
To obtain detailed User Guide information,
please visit www.lg.com.
EXTERNAL CONTROL
DEVICE SETUP
To obtain the external control device setup infor-
mation, please visit www.lg.com.
Problem Solution
Cannot control the TV
with the remote control.
Check the remote control sensor on the product and try again.
Check if there is any obstacle between the product and the
remote control.
Check if the batteries are still working and properly installed
( to , to ).
No image display and
no sound is produced.
Check if the product is turned on.
Check if the power cord is connected to a wall outlet.
Check if there is a problem in the wall outlet by connecting
other products.
The TV turns off
suddenly.
Check the power control settings. The power supply may be
interrupted.
Check if the Sleep Timer or Off Time feature is activated in
the TIME settings.
If there is no signal while the TV is on, the TV will turn off
automatically after 15 minutes of inactivity.
When connecting to the
PC (HDMI), ‘No signal’
or ‘Invalid Format’ is
displayed.
Turn the TV off/on using the remote control.
Reconnect the HDMI cable.
Restart the PC with the TV on.
To Next Page
Loading...
Need help?
General
