12
HOW TO REMOVE AND INSTALL THE PULL
OUT DRAWER
1. Removing Pull out Drawer
IMPORTANT: To avoid possible injury, product or
property damage, you will need two persons to
perform the following instructions.
• Pull the drawer open to full lower extension.
Remove the durabase by lifting it from rail system.
(Fig. 1)
Durabase
Fig. 1
• Remove the screws of the rail on both sides.
(Fig. 2)
screw
Fig. 2
CAUTION: When removing drawer door, do not
hold it by the handle. The door could fall down
and you may be injured. Grasp the door with both
hands as pictured below when removing.
CAUTION: When laying down the drawer, be
careful not to damage the floor or hurt your feet
with the sharp edges on hinge side.
• With both hands, hold both sides of the door
(Fig. 3) and pull it up to separate it from the rails.
(Fig. 4)
Fig. 3
Fig. 4
Rail tabes
Door
supports
• Push the rails back into drawer cavity. With both
hands, hold the center of the bar and push it in
so that both rails go back simultaneously. (Fig.5)
(Fig. 6)
Fig. 5
Fig. 6
REFRIGERATOR INSTALLATION
To Next Page
Loading...
Need help?
General
