Operating Instructions
Preparation before operation
Operating Instructions
How to Insert the Batteries
1. Remove the battery cover by pulling it according to the arrow
direction.
2. Insert new batteries making sure that the (+) and (-) of battery
are installed correctly.
3. Reattach the cover by sliding it back into position.
Use 2 AAA(1.5volt) batteries.
Do not use rechargeable batteries.
Storage and Tips For Using the Remote Controller
• The remote controller may be stored by mounting
it on a wall.
• To operate the room air conditioner, aim the
remote controller at the signal receptor.
Signal receptor
Receives the signals from the remote controller.(Signal receiving sound: two short beeps or one long beep.)
Operation indicating lamps
On/Off : Lights up during the system operation.
Sleep Mode : Lights up during Sleep Mode Auto operation.
Timer : Lights up during Timer operation.
Defrost Mode : Lights up during Defrost Mode or *Hot
Start operation (Heat pump model only)
: Lights up during outdoor unit operation.
(Cooling model only)
NEO Plasma : The function illustrates its dynamic mode by using a multiple lighting system.
Outdoor Unit
Operation
*Hot Start operation: Stops the indoor fan in Heating Operation to prevent cold air from blowing out from unit.
To Next Page
Loading...
Need help?
General
