20
MultiSITE CRC 1 Controller
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
ACCESSORIES INSTALLATION
Install Ceiling Motion Sensor
1. Consider sensor placement conditions before
installing sensor. Refer to “Sensor Placement”
on page 18.
2. Secure mounting plate to overhead surface
with two screws (Figure 16). Ensure screws are
tight and mounting plate does not move easily.
Do not torque screws.
3. Set sensor housing assembly
on mounting plate (Figure 16).
4. Rotate sensor housing assem-
bly clockwise until it locks in
place. Ensure sensor housing
assembly fits snugly to mount-
ing plate.
5. Test the ceiling motion sensor
again according to “Verify
Sensing Motion” on page 19.
Sensor Functions
Figure 17 shows the location of the function button
on the sensor module. Refer to “Table 2: Function
Button and LED Indicators” on page 29 for infor-
mation on using this button and the LED indicator
to set up sensor module operation.
Figure 16: Installing Sensor on Ceiling
Button
LED
Figure 17: Function Button and LED
Test Sensor with Controller
Refer to “ZigBee Pro Quick Setup” on page 28 for information
on how to test sensor operation.
To Next Page
Loading...
Need help?
General
