26 OPERATION
• Machine Clean
- The Machine Clean LED flashes every 30 cycles. To activate or deactivate the LED, refer to the
Using the Option Setting Mode topic.
•
8:88 : Digital Display
- The digital display on the control panel shows the ESTIMATED cycle time. When the cycle and
options are selected, the display shows the total estimated time to complete those selections.
During operation, the display shows the remaining estimated operating time.
• The estimated time shown on the display does not include delay times for heating water, etc.
•If Delay Start is selected, the display shows the delay time in hours.
• Cycle time may vary depending on the soil level of your load.
• CL : Control Lock
- The Control Lock feature helps prevent settings from being changed during a cycle. Selecting this
feature locks all of the buttons, except for the Power button, on the control panel. This feature
does not lock the door.
- While a cycle is running, press and hold Night Dry and Delay Start simultaneously for three
seconds to activate or deactivate Control Lock.
- To start a new cycle, deactivate Control Lock.
• Sanitized
- If the Steam option is added to a cycle, the Sanitized indicator stays lit at the end of the cycle if the
dishes were properly sanitized (except the Refresh cycle).
• Wi-Fi
- When the appliance is connected to the internet through a home Wi-Fi network, this LED
illuminates.
- Press and hold Remote Start for approximately three seconds to connect to the network.
d Cancel Button
• The drain pump activates and the cycle cancels. Once the dishwasher finishes draining, the power
turns off.
•Press and hold Start for three seconds to activate.
e Start Button
• To operate the machine, either press Start and close the door within four seconds or close the door
and press Start.
• An alert will sound when the door is not closed within 4 seconds after you press Start.
f Front Time Indicator
• This feature is only available on some models.
• The front time indicator feature shows the remaining cycle time while the cycle is running.
Wash Cycles
Select your desired cycle.
Auto
This cycle senses the soil amount and soil
toughness and is optimized to achieve the best
cleaning.
Normal
This cycle is for daily, regular, or typical use to
completely wash a full load of normally soiled
dishes. The Dry Boost Low option is
recommended for optimal energy efficiency. Select
the Night Dry option if leaving dishes overnight.
• After the cycle ends, the fan runs for an hour to
help vent the warm, moist air in the tub. You can
To Next Page
Loading...
Need help?
General
