27
Troubleshooting Guidelines
■ Troubleshooting Tips
To save you time and money, the following page will help answer your questions before a
service call.
Issue What to do
Dryer won’t run
It takes a long time
to dry
Clothes are covered
in Fluff
The drying time is
not consistent
Water is leaking
The clothes are
creased
The garments have shrunk
1. Check dryer is plugged in.
2. Check "Start" button is pressed.
3. Check door is properly closed.
4. Check room temperature is not below 5°C
5. Check a fuse is not blown or the circuit breaker is
tripped and replace them.
(Caution : electric dryers generally use two fuses or
breakers) After emptying the water container and
Cleaning filter during operation, you must press the
start button, then the dryer operates again.
1. Filter should be cleaned after each load.
2. Check water container is emptied.
3. Check cleanliness of condenser.
4. Select correct programme setting for fabric type
5. Check air ventilation grill or rear vents of dryer are not
obstructed
6. Check clothes are not excessively wet
7. Check the dryer is not overloaded
1. Check filter is clean
2. Check condenser unit is not clogged.
1. Check lint filter is empty
2. Check all the items in the dryer are clean
3. Check all the laundry has been correctly sorted by
fabric type
4. Check laundry is not overloaded
5. Check if there is any paper, tissues or other
degradable items amongst the laundry and remove.
The drying time for a load will vary depending on the
heat setting, the size of the load, the type of fabrics, the
wetness of the clothes and the condition of the lint filter.
Check if the door or seal cover is dirty or damaged.
Check the laundry is not overloaded. Try a shorter drying
time and remove items whilst they still retain a slight
amount of moisture. Use the anti-crease function
To avoid shrinkage, please follow the care and use
instructions for your garment, as some fabrics shrink
naturally when washed and other fabrics should not be
placed in a dryer.
To Next Page
Loading...
Need help?
General
