ENGLISH
HOW TO USE
FA
D
E
B
C
CONTROL PANEL FEATURES
POWER ON/OFF BUTTON
Press to turn the washer ON. Press again to turn
the washer OFF.
NOTE: If the washer remains idle for 4 minutes
after turning the washer off, the water in the tub
will drain.
NOTE: An alarm will sound 1 minute prior to
draining, and 'dr' will appear on the display. You
may restart the washer at this time. However,
once the washer initiates draining, all functions
will be suspended, and ‘dr’ will be displayed until
draining is complete.
CYCLE SELECTOR KNOB
Turn this knob to select the desired cycle. Once
the desired cycle has been selected, the standard
presets will be shown in the display. These
settings can be adjusted using the cycle setting
buttons before starting the cycle.
START/PAUSE BUTTON
Press this button to START the selected cycle.
If the washer is running, use this button to PAUSE
the cycle without losing the current settings.
NOTE: If you do not press the START/PAUSE
button within 4 minutes of selecting a cycle, the
washer automatically turns off.
NOTE: If the washer remains idle for 8 minutes
after pausing the cycle, the water in the tub will
drain.
A
B
CYCLE MODIFIER BUTTONS
Use these buttons to select the desired cycle
options for the selected cycle. Press the button
for that setting until the indicator light for the
desired value is lit.
OPTION BUTTONS
The option buttons allow you to select
additional cycle options and will light when
selected. Certain buttons also allow you to
activate special functions by pressing and
holding the button for 3 seconds.
For detailed information about the individual
options, please see the following pages.
LED DISPLAY
The display shows the settings, estimated
time remaining, options, and status messages
for your washer. The display will remain on
through the cycle.
D
E
C
F
13
To Next Page
Loading...
Need help?
General
