Caring for Your Dryer
20
C
aring for Your Dryer
1. Take
connecting
kit out.
Ventilation Grille and Cool Air
Inlet Grille
Vacuum the front ventilation grill 3~4 time a year to
make sure there must be no build-up of lints or dirts
which cause improper intake air flow.
Moisture Sensor?
This device senses the moisture remaining in
the contents of the laundry during operation
which means it must be cleaned all the time.
The main reason for cleaning this part is to
remove the build-up of lime scale on the surface
of sensor. Wipe the sensors inside drum (Shown
in the picture).
2. Separate
water
container
hose from
the kit.
3. Connect
drain hose
to the kit.
Condensed Water Drain-out
Normally, condensed water is pumped up to water
container where water is collected until emptied.
The water container is not the only method, water can
be drained out directly to drain hose especially when
dryer is stacked on top of washing machine.
With connecting kit for drain hose, you can simply
change water path and reroute water to the drainage
facility. Please follow the below steps.
Note
- The warm air is exhausted through the
ventilation grill.
- Adequate ventilation has to be provided
to avoid the back flow of gases into the
room from appliance’s burning other
fuels, including open fires.
To Next Page
Loading...
Need help?
General
