EasyManua.ls Logo

LG WM0642HW User Manual

LG WM0642HW
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
I N S TA L L AT I O N I N S T R U C T I O N S
When removing the washer from the carton
base, be sure to remove the foam tub support
in the middle of the carton base.
If you must lay the washer down to remove the
base packaging materials, always lay it carefully
on its side. Do NOT lay the washer on its front
or back.
IMPORTANT: To prevent internal damage
during transport, the washer is equipped with
4 shipping bolts and plastic retainers. These
bolts and retainers MUST be removed before
operating the washer.
Failure to remove shipping bolts and retainers
may cause severe vibration and noise, which can
lead to permanent damage to the washer. The
cord is secured to the back of the washer with
a shipping bolt to help prevent operation with
shipping bolts in place.
Remove the retainers by turning them slightly
while pulling. Rotate and press the hole caps
into the shipping bolt holes.
Starting with the bottom 2 shipping bolts,
use the included wrench to remove the
4 shipping bolts by turning them
counterclockwise.
1
Shipping
Bolts
2
NOTE: Save the bolts and retainers for
future use. To prevent damage to internal
components, the shipping bolts and
retainers must be installed when
transporting the washer.
Retainer
Hole Cap
Carton Base
Foam Tub
Support
UNPACKING AND REMOVING SHIPPING BOLTS
11

Table of Contents

Other manuals for LG WM0642HW

Questions and Answers:

LG WM0642HW Specifications

General IconGeneral
TypeFront Load Washer
Energy StarYes
ColorWhite
Steam WasherNo
Voltage120 V
Frequency60 Hz
Spin Speed1, 200 RPM

Summary

IMPORTANT SAFETY INSTRUCTIONS

GROUNDING AND INSTALLATION SAFETY

Proper grounding procedures and critical safety warnings for washer installation.

INSTALLATION INSTRUCTIONS

LOCATION AND CLEARANCES

Guidelines for selecting a proper location, required clearances, and flooring for installation.

PREPARATION AND CONNECTIONS

Steps for unpacking, removing shipping bolts, and connecting water and drain lines.

LEVELING AND STABILITY

Procedure for adjusting leveling feet to ensure the washer is stable and operates correctly.

HOW TO USE

CONTROL PANEL AND OPERATION

Explanation of control panel features and how to operate the washer.

TROUBLESHOOTING

Related product manuals