11INSTALLATION
ENGLISH
Unpacking and Removing
Shipping Material
Remove all shipping materials from the washer for
proper operation and inspect it for shipping
damage.
• Failure to remove shipping materials can cause
excessive noise and vibration.
Unpacking Shipping Material
*Some models do not ship with drum support.
Lift the washer off the foam base.
• After removing the carton and shipping
material, lift the washer off the foam base.
• Make sure the plastic drum support
a* comes
off with the base and is not stuck to the bottom
of the washer.
• If you must lay the washer down to remove the
carton base b, always protect the side of the
washer and lay it carefully on its side. Do not lay
the washer on its front or back.
Removing Shipping Material
1 Remove the bolt assemblies.
• Starting with the bottom two shipping bolts
c , use the included wrench to fully loosen
all 4 shipping bolts by turning them
counterclockwise.
• Remove the bolt assemblies (bolts and
retainers) by wiggling them slightly while
pulling them out.
• All 4 bolt assemblies must be completely
removed from the unit to avoid product
damage.
• Make sure to remove the entire bolt assembly,
including:
- metal bolt and washer
- rubber damper
- plastic rod
2 Install the hole caps.
• Locate the hole caps
d included in the
accessory pack or attached to the back of
the washer. Install the caps in the holes left
by the bolt assemblies.
F 24'' (60 cm)
G1/4'' (0.5 cm)
Dimensions and Clearances
*
To Next Page
Loading...
Need help?
General
