C
leaning and Maintenance
33
Care and Maintenanc
e
When water supply into the tub is not clean or the filter is clogged with particles (such as sand), clean the
filter in the inlet valve occasionally.
(The power cord and water tap diagrams may vary according to the country)
To Clean the Filter in the Inlet Valve
Cold water washing
Close the tap before turning on the power.
Select both HOT/COLD and then press the
[START/PAUSE] button to completely
remove all water pressure from the hoses.
• If you always use COLD water, we recommend that a WARM or HOT wash be used at a regular
intervals e.g. every 3rd wash should be at least a WARM one.
When you have finished
• Turn off taps to prevent the chance of flooding should a hose burst.
• Always unplug the power cord after use.
After removing the water supply
hose pull out the filter.
Then use a brush to clean the filter.
Turn off the power before
pulling out the cord.
Replace the filter after cleaning it.
1 2
3 4
NOTE
• Before cleaning the filter, the impurities in the water supply hose should be removed.
NOTE
• Check if water leaks after reassembling. (The Rubber ring must remain in the cap)
To Clean the Pump casing (for pump model)
Place a towel on the
floor under the drain
pump cap. Excess
water will flow out.
Remove any foreign
objects and fluff inside
pump casing and from the
filter.
Replace the cap. Insert the filter along
the filter & cap guide ribs inside the pump casing.
Cap guide rib must lock with correct position and
Filter must face the filter guide ribs inside
pump casing and then securely turn the cap
clockwise.
1 2 3 4
Turn the cap
counter-
clockwise and
pull it out.
To Next Page
Loading...
Need help?
General
