Lightware DVI-OPT-RX110 User Manual

www.lightware.eu DVI-OPT-TX110 firmware version: 1.1.6
For technical support contact support@lightware.eu Document revision: 1.0
DVI-OPT-TX110 and DVI-OPT-RX110
Quick Start Guide
DVI connector
Connect to DVI source for transmitter use.
Connect to display device to learn EDID.
Power LED
Lights green if the power supply is sufficient.
(DVI or external adaptor supply)
EDID LED
Three color LED displays EDID status.
See legend for indications.
LEARN button
Press for 2 seconds to activate learn mode.
Press for 10 seconds to restore factory EDID.
Power connector
Barrel plug receptacle for external power adaptor.
Fiber connector
SC type receptacle for multimode fiber output.
Thumb-screw
Recessed, slotted thumbscrew for easy mounting by
hand or by screwdriver.
DVI connector
Connect to DVI display.
Power LED
Lights green if the unit is powered on.
Hotplug LED
Indicates that the display device is connected correctly.
Laser LED
Green light indicates that the laser is properly detected
on the optical input.
Power connector
Barrel plug receptacle for external power adaptor.
Fiber connector
SC type receptacle for multimode fiber input.
Thumb-screw
Recessed, slotted thumbscrew for easy mounting by
hand or by screwdriver.
Power connector
5
Fiber connector
6
EDID LED
3
Thumb-screw
7
Learn button
4
DVI connector
1
Power LED
2
Power connector
5
Fiber connector
6
Laser LED
3
Thumb-screw
7
DVI connector
1
Hotplug LED
3
Power LED
2
1
1
2
2
3
3
4
4
5
5
6
6
7
7

Lightware DVI-OPT-RX110 Specifications

General

Brand	Lightware
Model	DVI-OPT-RX110
Category	Transmitter
Language	English