EasyManuals Logo
Home>Lippert Components>Lifting Systems>Power Gear

Lippert Components Power Gear User Manual

Lippert Components Power Gear
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
Rev: 11.23.22 Page 8 CCD-0004307
Description Probable Cause Corrective Action
Touch Pad will not
turn ON
Coach ignition not in
run position
Turn on the ignition and start the coach. The
engine must be running for the jacks to operate.
Blown fuse or tripped
circuit breaker
Replace fuse or reset breaker
Auto Shut Off Push On/Off button to turn the control back ON.
Jacks will not extend.
Pump is not running
Blown fuse or tripped
circuit breaker
Replace fuse or reset breaker
Batteries are weak
Turn on the ignition and start the coach. Wait a
few minutes to allow the batteries some time to
charge. The engine must be running for the jacks
to operate.
Jacks will not extend
(or are extending
slowly), pump is
running
Fluid level low
Fill tank to proper level with automatic
transmission fluid, see tip sheet 140.
Batteries are weak
Turn on the ignition and start the coach. Wait a
few minutes to allow the batteries some time to
charge. The engine must be running for the jacks
to operate.
Jacks will not retract
fully
Air in the system
Check for coils in hose. Remove the coil if
present then extend all jacks to full extension,
then retract fully. Repeat 4 cycles waiting a few
minutes between cycle
Troubleshooting
The following chart contains troubleshooting tips if your system is not operating properly, and the touch
pad is not giving you a trouble code.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lippert Components Power Gear and is the answer not in the manual?

Lippert Components Power Gear Specifications

General IconGeneral
BrandLippert Components
ModelPower Gear
CategoryLifting Systems
LanguageEnglish

Related product manuals