Rev: 06.09.20 Page 5 CCD-0002734
II. Two beeps will sound off and the LED will blink greentwice. Continue to hold the button.
III. After the indicator beeps three times, release the button. The LED will blink green three times.
B. The Alert Indicator’s LED will briefly blink blue and emit a "happy tone," indicating it has been
linked to theRepeater.
6. The Alert Indicator is now linked to the Repeater.
NOTE: The Repeater's Status LED will indicate green, yellow or red to indicate certain conditions (see Step
7). The number of blinks of the LED, regardless of color, also indicates battery status (see Step 8).
7. Wait for the Repeater’s Status LED to turn off, then press and release the Alert Indicator’s button. The
indicator’s LED will flash as follows:
• Green to indicate the Repeater is in range and monitoring; tires within pressure and temperature limits.
• Yellow if there is no connection or out of range of the Repeater; cannot detect tire status.
• Red to indicate a fault, either high/low pressure or temperature is out of range; Indicator will beep
for 10 seconds when tire issue is seen for the first time. LED will continue to blink red until fault is
corrected.
• Red followed by blue notes Indicator is not linked to the Repeater.
8. Battery state indicators are as follows (regardless of LED color in step 7):
• 3 blinks - Good, full charge
• 2 blinks - Low, not full charge
• 1 blink - Critical, needs charging
Fig. 2
D
Fig. 3
A
B
C
A
B
To Next Page
Loading...
Need help?
General
