Application Note
Falcon-NEO System Restore v3.2u3 Page 1 of 12
Revised date: December 2020
Logicube, Inc. • 19755 Nordhoff Pl.,Chatsworth, CA 91311 USA• tel:+1-818-700-8488• fax:+1-818-435-0088
www.logicube.com
Falcon®-NEO System Restore
1.0 INTRODUCTION ........................................................................................................................ 1
2.0 WARNING: LOG FILES WILL BE DELETED .......................................................................... 2
2.1 REQUIREMENTS FOR BACKING UP THE LOG FILES – FALCON-NEO DOES NOT BOOT ........................................ 2
2.2 BACKING UP THE LOG FILES – FALCON-NEO DOES NOT BOOT ........................................................................ 2
3.0 USING A BOOTABLE USB FLASH DRIVE WITH THE SYSTEM RESTORE ......................... 3
4.1 REQUIREMENTS .............................................................................................................................................. 3
4.2 CREATING THE RECOVERY USB FLASH DRIVE .................................................................................................. 4
4.3 USING THE RECOVERY FLASH DRIVE ................................................................................................................ 7
4.0 USING THE BUILT-IN SYSTEM RESTORE ........................................................................... 9
3.1 BUILT-IN SYSTEM RESTORE (STEP-BY-STEP) ................................................................................................... 9
5.0 FIRMWARE UPDATE ........................................................................................................... 12
1.0 Introduction
This document provides instructions on how to perform a system restore on the Forensic Falcon-NEO. There
are two ways to restore the Falcon-NEO:
• Using a bootable USB flash drive with the system restore
• Using the built-in system restore
To Next Page
Need help?
General
