GB
17
Operation
Ensure the OFF/ON dial is turned to 0 before connecting the power.
1. Open the lid and put food into the jug. Close the lid and slightly push the lid to release
the air pressure from the jug.
2. Make sure the jug, measuring cup and the lid are secure and the jug is properly tted
and locked to the base.
3. Plug your blender into the mains and turn the OFF/ON dial to P, 1 or 2. The blue light
will illuminate.
4. To stop the operation or power o, turn the OFF/ON dial to 0.
Blender’s Operation Modes
Speed
selection
Turn the OFF/ON dial to 1 or 2 to adjust the blending speed while
blending.
Pulse
mode
Turn the OFF/ON dial to P to run the blender intermittently rather
than continuously. Turn the dial to this position until you achieve the
desired result.
During blending, you can feed in small amounts of food or liquid through the jug lid. To do
this:
1. Stop the blender and hold the lid.
2. Turn the measuring cup slowly clockwise to free it and then lift it out.
3. Gradually feed pieces of food or liquids into the jug through the feeder.
4. Fit the measuring cup back when you have nished.
• Do not run the appliance continuously for more than 2 minutes. Allow the
blender to rest for 1 minute before using it again.
• Never blend hot liquids in the blender. This is dangerous as the pressure inside
the jug will build up and may cause the contents to escape from the jug.
• If you spill liquid on the blender base, immediately switch o, unplug and wipe
dry.
• Do not run the appliance without securing the lid and measuring cup.
L100BL14E-BR_W16E_IB_5L_RC_161118_grace.indb 17 18/11/16 4:29 pm
To Next Page
Loading...
General