Location
When selecting a position for your unit you should make sure the floor is flat and firm,
and the room is well ventilated with an average room temperature of between 16°C and
43°C. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator (must be at
least 50 cm away). Also avoid direct sunlight as it may increase the electrical consumption.
Extreme cold ambient temperatures may also cause the unit not to perform properly. This
unit is not designed for use in a garage or outdoor installation. Do not drape the unit with
any covering.
When installing the unit, ensure that 100 mm of free space is left at both sides, 75 mm at
the rear and 100 mm at the top of the unit. The door can be opened to the right or the left,
depending on what better suits the location. Please ensure there is adequate space for the
door to fully open.
Reversing the Door Swing
Tools required: Phillips style screwdriver / Flat bladed screwdriver / Craft knife
1. Tilt the unit slightly towards the rear and
prop it securely. Two people are required
to tilt the unit during the door reversal
process.
Installation
• If you want to have the door swing reversed, we recommend that you contact a
qualified technician. You should only try to reverse the door yourself if you believe
that you are qualified to do so.
• Ensure the unit is unplugged and empty.
• Adjust the two levelling feet to their highest position.
• To take the door off it is necessary to tilt the unit backwards. You should rest the
unit on something solid so that it will not slip during the door reversing process.
• All parts removed must be saved to do the reinstallation of the door.
• Do not lay the unit flat as this may damage the coolant system.
• Two (2) people are required to handle the unit during assembly.
2. Unscrew the two screws which are fixing
the middle hinge.
To Next Page
Loading...
Need help?
General
