21
Hints and Tips
Problem Possible Solutions
My hob burner does
not light
• Check the cooker is switched on.
• Check the control is pushed in and turned on and the supply to the house
is working. You should hear the gas when you turn a burner on.
• The ignitors may be dirty. Clean them gently with a small nylon brush such as
a toothbrush.
• The burner parts may not be located properly. Check the assembly and make sure
the burner cap is sitting flat.
My burner flames are
yellow or hard to start
• The burner parts may not be located properly. Check the assembly and make sure
the burner cap is sitting flat.
• If you use bottled gas this may indicate you are getting near the end of the bottle.
• Check the burner parts are clean and dry.
• The gas pressure may not be at the correct level.
• Check with your approved service agent.
• Your cooker may not be set up for the gas you are using. Check this with your
approved service agent.
One of my burners
has an uneven flame
• Check the burner parts are clean and dry. Check the assembly and make sure the
burner cap is sitting flat.
My burner goes out
when I let go of the
control
• 'Flame supervision Device (FSD)' is operating. Hold in the control for approximately
5 to 10 seconds after the burner has lit. Releasing the control too soon will
extinguish the flame.
The flame goes out
at low settings
• The gas supply pressure may be low. Check this with your approved service agent.
• The low setting may have been adjusted incorrectly. Check this with your approved
service agent.
My burners do not
turn down much
(when running on
bottled gas or LPG)
• Your burners may not have been adjusted correctly. Check this with your approved
service agent.
The flame tips are
very yellow
• Call your approved service agent.
There are
objectionable odours
• During first time use, a small amount of smoke or odours will be noticeable from
the Oven or Grill. This is the protection to prevent corrosion burning off. It should
disappear after approximately 15 minutes.
• Call your approved service agent.
The flame appears to
lift off the burner
• Call your approved service agent.
There is an electricity
failure
• If there is an electricity failure, you can still use your cooker. Light the burners by
holding a candle lighter close to the side of the burner and turning the controls
to the High position. Wait until the flame is burning evenly before adjusting.
The control must still be held down for 5 to 10 seconds after the burner has lit.
Releasing the control too soon will extinguish the flame.
Logik Free Standing Twin Cavity Gas Cooker LFTG60B16/W16.indd 21Logik Free Standing Twin Cavity Gas Cooker LFTG60B16/W16.indd 21 14/12/2020 16:0714/12/2020 16:07
To Next Page
Loading...
Need help?
General
