25
Cleaning the Filter Net of the Water Supply Hose
1. Turn the water supply o at the tap.
2. Remove the water supply hose from the tap.
3. Manually remove the lter net located on the tap side of the water supply hose and clean
using a small brush (e.g. a toothbrush).
4. Return the lter net to its original position.
5. Re-connect the water supply hose to the tap and turn the tap back on, checking for leaks.
Before cleaning the drain lter, switch o and unplug the machine.
1. Carefully loosen the drain lter. Water may drain out - this is normal.
2. Unscrew the lter to remove it.
3. Remove any lint and debris before carefully replacing the lter.
4. Turn the lter clockwise to screw back into place.
about
50°C
Cleaning the Drain Filter
Preventing a Frozen Water Supply Hose
If your machine is delivered in freezing weather conditions, leave it
at room temperature for 24 hours after you’ve set it up before using
it. This ensures there’s no ice blocking the water supply hose. If your
water supply hose freezes, add 2 or 3 litres of warm water to the
drum. Then run “Express” programme without detergent.
about
50°C
Be careful not to burn yourself while cleaning the drain lter. Water draining from
the lter compartment may be hot after a high temperature wash.
LI8W6D17_IB_RC_190830_grace.indd 25 30/8/2019 6:12 PM
To Next Page
Loading...
Need help?
General
