G920 Driving Force Racing Wheel FAQs 44
Please click on the appropriate links below for the mounting templates.
● Wheel Unit Bolt Template: logitech.com/assets/53963/templates.pdf
● Pedal Bolt Template: logitech.com/assets/53963/2/templates.pdf
For more information on how to mount and secure the G920 racing wheels using bolts, see
Mount and secure the G920 racing wheel using built-in bolt mounting points.
NOTE: You can also use the clamping system on the G920 to secure the wheel and pedal
units. For more information, see Mount and secure the G920 racing wheel using the clamping
system.
● Mount and secure the G920 racing wheel using the clamping system
○ Wheel Unit
○ Pedal Unit
○ Cable Management
NOTE: For details on mounting the G920 racing wheels using bolts, see Mount and secure the
G920 racing wheel using built-in bolt mounting points.
Wheel Unit
G920 racing wheels are equipped with a built-in clamping system that can be mounted to a
table or desk, or mounted to a racing rig using built-in bolt mounting points.
NOTE: Before mounting and securing the wheel unit, make sure to connect the power adapter,
pedal unit, and Driving Force Shifter attachment (where applicable) to the connection ports
on the underside of the wheel unit. See the Cable Management section for details.
To use the clamping system to mount the wheel unit:
1. Push down and then rotate the clamp knobs to lock or unlock.
2. Rotate the clamp knobs to tighten or loosen clamps.