Your Revue receives RF (radio frequency) signals from the Keyboard Controller
and then flashes IR (infrared) commands to your other devices. This allows you to
control your TV, STB and AVR from your Keyboard Controller.
If some of your devices are non-responsive, they are probably not receiving the
IR signal from Revue. You can extend the IR signal range with the IR mini blaster.
Plug the mini blaster into the IR Blaster port on the back of the box and then
position it near the non-responsive device.
Mini blaster
TV Cam
Logitech TV Cam
sold separately
Set up IR mini blaster if needed Using supported devices
After you have completed the Google TV setup, you can add other supported
Logitech devices.
For example, if you have a Logitech TV Cam, simply plug it into a USB connector
on the back of Revue and follow the on-screen prompts and the product guide
to set up.
4
Tip: Each entertainment system is different, so you may need to get creative
when placing your Mini Blaster. IR signals cannot pass through surfaces, but they
can bounce off surfaces to reach their target.
To Next Page
Loading...
Need help?
General