English - 30
Chapter 6 Descriptions of Major
Functions
6.1 I would like to switch to VC-A51S
1. Press [Camera 1 ~ 3] on the remote control to select VC-A51S.
Camera 1 ~ 3 is selected with IR SELECT.
6.2 I would like to save the current lens position data
1. Hold [Preset + ID] on the remote control to save the current position
data.
ID shall be a digit [0 ~ 9].
Use VISCA Command to store position data to [0 ~ 127]
6.3 I would like to clear the saved position data
1. Hold [Reset + ID] on the remote control to clear the given position
data.
ID shall be a digit [0 ~ 9].
Use VISCA command to clear position data stored in [0 ~ 127]
6.4 I would like to turn on the back light compensation
function
1. Press [Back Light] on the remote control to turn on or turn off the back
light compensation
6.5 I would like to adjust the shooting angle of the lens
1. Press [Tilt ] or [Tilt ] on the remote control to adjust the angle
upward or downward.
2. Press [Pan ] or [Pan ] on the remote control to adjust the angle to
right or left.
3. Press [Pan - Tilt Reset] on the remote control to reset the angle to the
center point.
6.6 I would like to hide the preset image switch
(Motionless Preset)
1. Press [MENU] to activate the setting menu.
To Next Page
Loading...
Need help?
General
