1. Unpacking the bath lift
Openthepackagingandensurethebathliftisnotdamagedandthatallpartsareincluded.Ifithas
beendamagedintransitorpartsaremissing,contactyoursupplierimmediately.
Insidetheboxyouwillnd:
• Abathlift,completewithtwosideapsandhandcontrolattached(see g 1)
• Abattery(see g 2)
• Abatterychargerwithchargingcradleattached(see g 2)
Ifyourbathliftissuppliedwithoptionalsoftcovers,tthematthisstage
(seecoverttinginstructions).
Beforeinstallingorusingthebathliftforthersttime,ensureyouchargethebattery
(seesection2,“Chargingthebattery”below).
2. Charging the battery
Before rst operation of your bath lift or after long periods of non-use (typically 7-10 days),
fully charge the battery as follows. A at battery will take up to 2 hours to charge.
i) Slidethebatteryintothetracksonthechargingcradleuntilitclicksintoplace(see g 2).
ii) Plugthechargerintoasocket/outletoutsidethebathroomandswitchontheelectricitysupply
(ifapplicable).
iii) Thelightindicatoronthechargerboxwillinitiallyashinaquicksequenceofred,green,red,
green, before a constant red light appears to indicate charging is in progress (see g 2).
iv) Whenthebatteryhasbeenfullycharged,theredlightonthechargerboxturnstoaconstant
greenlight,whichindicatesthebatteryisreadyforuse.Werecommendchargingthebattery
aftereachbathwhereverpossibleandleavingitonchargeuntilyournextbath.Thebattery
cannot be overcharged.
v) Whenyouarereadytouseyourfullychargedbattery(seeparagraphiv),switchothesocket/
outletorremovethechargerfromthesocket/outlet,then ensure you disconnect the battery
from the charging cradle.(Thispreventsthebatterydischargingandwillresetthecharger
readyforitsnextuse.)
5
Diagrams for operation and explanation of use are on the
fold-out diagram sheet attached to the rear of this booklet