Lumiscope 1143 User Manual

To apply the cuff
A. Remove all watches, jewelry,
etc. prior to attaching the wrist
monitor. Clothing sleeves
should be rolled up and
the cuff should be wrapped
on bare skin for correct
measurements.
B. Apply cuff to left wrist with
palm facing up as Fig. A.
C. Make sure the edge of the
cuff is about 1 cm (1/2 an
inch) from the palm as Fig. B.
D. In order to insure accurate
measurements, fasten
the velcro strap securely
around your wrist so there
is no extra space between
the cuff and the wrist.
Note: If the cuff is not wrapped tight enough, the measurement
values will be inaccurate.
Applying the Cuff
10
Fig. A
Fig. B
13
Measurement Procedures
To start the measurement
Note: In order to get your correct measurement result and,
to avoid erroneous measurements, you should be seated
quietly. Your arm, hand, and fingers should be still during the
measurement procedure
.
A. Press the “START/STOP” button. The display will initially
show a flashing “0”.
B. After the “0” stops blinking, the unit will automatically
inflate to the appropriate inflation level based on the
user's pulse oscillations. Measurement will then begin.
Initial Display
Flashing “0”
Start / Stop

Lumiscope 1143 Specifications

General

Type	Automatic
Date imprinting	Yes
Number of users	1 user(s)
Memory registers	90
Placement supported	Wrist
Battery type	AAA
Number of batteries supported	2
Display type	LCD