Lux Tools E-RT-550/27 - Maintenance, Troubleshooting, and Disposal; Cleaning and Maintenance; Troubleshooting Common Issues; Disposal Guidelines

8
• Only take the thread as close as absolutely nec-
essary to posts, walls, fences etc. Solid objects
will wear the thread.
• Tree trunks, young tr
ees and bushes may be
damaged by the thr
ead.
Trimming edges
►P.4, item6
– Press in and hold the locking button(10).
– Rotate the cutting head(9) by 90°.
– Release the locking button(10) again.
– Guide the unit, as shown, slowly along the edge
of the lawn (►P.4, item8).
Cleaning and maintenance
Cleaning and maintenance overview
Before each use
If necessary
Replacing the thread spool
Removing the thread spool
►P.4, item9
– Press the locking mechanism(17) in.
– Remove the cover(18).
– Pull out the cord spool.
Inserting the thread spool
►P.4, item9
– Feed both thr
eads in the openings(19) of the
spool housing.
–
Press the thr
ead spool into the spool housing.
Pull the thr
eads out through the openings.
– Mount cover(18) and allow to engage.
Storage, transportation
Storage
– Store the tool in a dry and well ventilated place.
Transportation
– When dispatching, try to use the original pack-
aging, if possible.
Troubleshooting
In many cases small defects can lead to a malfunc-
tion. You will usually be able to deal with these your-
self. Please refer to the table below before contact-
ing your local vendor. This may save you a lot of
effort and quite often money.
If you are unable to eliminate the error yourself,
please contact your local vendor directly. Please
remember that repairs carried out by non-profes-
sionals will invalidate your warranty claim and may
cause additional costs.
Disposal
Disposal of the appliance
Appliances which are labelled with the adja-
cent symbol must not be disposed of in
household waste. You must dispose of such
old electrical and electronic equipment sep-
arately.
– Please check with your local authority about the
possibilities for correct disposal.
WARNING! Risk of injury! When using the
cutting head upright, particular care should
be taken. Always maintain sufficient dis-
tance to the cutting thread.
NOTICE! Risk of damage to the unit!
Avoid contact with solid surfaces to prevent
rapid wear of the thread.
Note: The guide roller(6) only serves for
easier guidance when trimming edges. It
should not be used for brush cutting and
has no influence on the cutting height.
DANGER! Risk of injury! Prior to conduct-
ing maintenance or cleaning: Unplug from
the power source.
Note: Clean unit immediately after every
use. Dried grass remains are very hard, and
are very difficult to remove.
What? How?
Check the power cable
and connector for dam-
age.
Conduct a visual inspec-
tion and have the cable
replaced by an electrician
if necessary.
What? How?
Cleaning the device Wipe the unit with a damp
cloth.
Replace thread if it is too
short
►Replacing the thr
ead
spool– p.8
DANGER! Risk of injury! Unprofessional
repairs may mean that your unit will no
longer operate safely. This endangers you
and your environment.
Error/Fault Cause Remedy
The motor does not work. No power supply? Check the cable, plug, and the fuse.
Defective connecting cable? Contact your local vendor.
Threads don’t unwind. Thread used up? ►Replacing the thr
ead spool–
p.8.
Thr
ead spool blocked? Remove the cause of the blockage
(►Removing the thr
ead spool–
p.8).
GB
Rasentrimmer_401129_401130.book Seite 8 Montag, 31. August 2015 9:45 09