Mackie SRM V-CLASS Series User Manual

Owner’s Manual
13
Owner’s Manual
All four may also be muted (via the SRM
Connect app). Red fader caps indicate
a muted channel, while white fader caps
indicate unmuted channels. A muted
channel will unmute once a level is changed
via the speaker control knob (or SRM Connect).
Let’s expand on the meters for a moment. The peak
holder meter peaks at +6 dBu and a 4: compressor
engages at approximately +8 dBu. This means that
the loudspeaker is compressing when the peak/hold
indicator is hitting the top of the meter scale. It also
signifies that you are nearing the end of available
headroom. As you continue to raise the volume,
you’re continuing to compress the signal, as well.
This is reflected in compression of the metering – which
will remain at or near the top of the meter strip – and
reflected in the acoustic output.
In addition to raising and lowering the input
and output levels, the mixer view is where to adjust
the EQ parameters and access the Menu screen, too.
These icons are located underneath each meter.
In order to change a channel’s EQ, push the speaker
control knob when the desired channel’s EQ icon
is illuminated.
Next, push the speaker control knob again once
the EQ you want to change is illuminated. See below.
1 2 BT Main 1 2 BT Main
1 2 BT Main 1 2 BT Main
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
The EQ ranges are as follows:
• High: ±2 dB @ 5 kHz
• Mid: ±2 dB @ 2.5 kHz
• Low: ±2 dB @ 80 Hz
• HPF: 80 Hz – 50 Hz @ 2 dB per octave
[Channels  and 2 only]
As seen below, we changed the channel  high,
mid and low EQ to +5 and the HPF setting to 0 Hz.
Press the speaker control knob to return to the
previous screen once the EQ settings you desire
have been dialed in.
In addition to the four EQ choices shown above,
there’s a fifh and final selection: the lef-facing arrow.
Illuminating and selecting this simply returns you
to the main mixer screen.
Other than the aforementioned EQ settings screen,
this is also where to access the menu screen. From
the mixer screen, simply rotate the speaker control
knob right until the bottom right icon is illuminated (A).
Then push the knob to enter the menu screen (B).
Let’s take a look and see what the menu screen does.
The first step is to flip the page!
1
Mid 0dB
Low 0dB
HPF 20Hz
High +5
1
Low 0dB
HPF 20Hz
High 0dB
Mid +5
1
Mid 0dB
HPF 20Hz
Low +5
1
Mid 0dB
Low 0dB
HPF 110Hz
High 0dB High 0dB
1
High 0dB
Mid 0dB
Low 0dB
HPF 20Hz
1 2 BT Main
MIXER MODE SUB
DELAY
CONFIG
BT
(A) (B)

Mackie SRM V-CLASS Series Specifications

General

Brand	Mackie
Model	SRM V-CLASS Series
Category	Speakers
Language	English