WATTAGE OUTPUT CHART
• The power - level is set by pressing the POWER pad. The chart shows the display, the power level
and the percentage of power.
OPERATION PROCEDURE
This section includes useful information about oven operation.
1. Plug power supply cord into a standard 3 - pronged 15 Amp, 120V AC 60Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
2. The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
8
1
The oven light is on only when the micro-
wave oven is operating.
2
The oven door can be opened at any time
during operation by touching the door
release button on the control panel. The
oven will automatically shut off.
3
Each time a pad is touched, a BEEP will
sound to acknowledge the touch.
4
The oven automatically cooks on full
power unless set to a lower power level.
5
The display will show “ : 0 ” when the oven
is plugged in.
6
Time clock returns to the present time
when the cooking time ends.
7
When the STOP/CLEAR pad is touched
during the oven operation, the oven stops
cooking and all information retained.
To erase all information (except the
present time), touch the STOP/CLEAR
pad once more. If the oven door is opened
during the oven operation, all information
is retained.
8
If the START pad is touched and the oven
does not operate, check the area between
the door and door seal for obstructions
and make sure the door is closed
securely.
The oven will not start cooking until the
door is comletely closed or the program
has been reset.
Make sure the oven is properly installed
and plugged into the electrical outlet.
Touch POWER pad
Power level (Display)
Approximate Percentage
Once the Touch of Power
POWER P-HI 100%
9 P-90 90%
8 P-80 80%
7 P-70 70%
6 P-60 60%
5 P-50 50%
4 P-40 40%
3 P-30 30%
2 P-20 20%
1 P-10 10%
0 P-0 0%
MCD790W(¿ )-631Q2A 02.2.15 6:39 PM ˘`8
To Next Page
Loading...
Need help?
General
