10
Draw a cutting line on the workpiece. Insert the edge fence
into the hole in the front of the tool. Align the blade edge with
the cutting line.
Adjust the edge fence until it comes in contact with the side
of the workpiece, then secure it by tightening the screw.
When planing, move the tool with the edge fence flush with
the side of the workpiece. Otherwise uneven planing may
result.
Maximum shiplapping (rabbeting) depth is 9 mm (11/32”).
You may wish to add to the length of the fence by attaching
an extra piece of wood. Convenient holes are provided in the
fence for this purpose, and also for attaching an extension
guide (optional accessory).
1. Blade edge
2. Cutting line
1
2
1
2
002582
1. Screw
2. Edge fence
1
2
002583
002584
To Next Page
Loading...
Need help?
General
