Makita 1902 User Manual

11
Chamfering
To make a chamfering cut as shown in the figure, align the
“V” groove in the front base with the edge of the workpiece
and plane it.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the chip cover.
1. “V”groove
003634
1
002587
1. Limit mark
1
001145
1. Chip cover
2. Screwdriver
1
2
002597

Makita 1902 Specifications

General

Brand	Makita
Model	1902
Category	Planer
Language	English