11
Chamfering
To make a chamfering cut as shown in the figure, align the “V” groove in the
front base with the edge of the workpiece and plane it.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Sharpening the planer blades
For standard blades only
Always keep your blades sharp for the best performance possible. Use the
sharpening holder to remove nicks and produce a fine edge.
1. “V” groove
003634
1
004901
1. Sharpening holder
1
002588
To Next Page
Loading...
Need help?
General
