8
Remove the trimmer guide from the tool. Install the
trimmer shoe on the guide holder with the adjusting
screw and the clamp screw (B). Loosen the clamp
screw (B) and adjust the distance between the bit and
the trimmer shoe by turning the adjusting screw (1 mm
or per turn). At the desired distance, tighten the clamp
screw (B) to secure the trimmer shoe in place. When
cutting, feed the tool in the direction of the arrow on the
trimmer shoe.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
• Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
1
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Tak e o u t th e w o rn car b on br u s he s , ins e r t t he n ew o n es
and secure the brush holder caps.
1
2
007116
To ma i nta i n p r o duc t SA F E TY an d REL I A BI L I TY, re pair s ,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Router bits
Straight bit
005116
mm
D A L 1 L 2
20 50 15
20 6
20E 1/4"
86
8E 1/4"
850
18
66
6E 1/4"
650
18
006485
"U"Grooving bit
R
005117
mm
DAL 1L 2
66
6E 1/4"
66028
R
3
006486
1. Screwdriver
2. Brush holder
cap
1. Limit mark
To Next Page
Loading...
Need help?
General
