Makita 4350FCT User Manual

9
Hex wrench storage
When not in use, the hex wrench can be conveniently stored.
OPERATION
CAUTION:
• Always hold the tool base flush with the workpiece.
Failure to do so may cause blade breakage, resulting in
a serious injury.
Turn the tool on and wait until the blade attains full speed.
Then rest the tool base flat on the workpiece and gently
move the tool forward along the previously marked cutting
line. When cutting curves, advance the tool very slowly.
Bevel cutting
CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the tool base.
With the tool base tilted, you can make bevel cuts at any
angle between 0˚ and 45˚ (left or right).
Loosen the bolt on the back of the base with the hex wrench.
Move the base so that the bolt is positioned in the center of
the bevel slot in the base.
1. Base
2. Hex wrench
1
2
001912
1. Cutting line
2. Base
1
2
001913
001914
1. Base
2. Bolt
3. Hex wrench
1
2
3
001915

Makita 4350FCT Specifications

General

Stroke length	26 mm
Cutting depth in wood	135 mm
Cutting depth in non-alloyed steel	10 mm
Output power	720 W
Power source	AC
No-load stroke rate	2800 spm
Bevel adjustment	Yes
Bevel capacity (max)	45 °

Weight and Dimensions

Weight	2585.48 g