7.2 Maintenance work
7.2.1 Replacing the waste
bag
1. Open the retaining clamps
and remove the upper sec-
tion of the cleaner from the
dirt tank.
2. Carefully remove the waste
bag connection (1) from the
inlet fitting.
3. Close the waste bag connec-
tion with the slide (2).
4. Close the waste bag using
the cable binder (3).
5. Dispose of the dirt in accord-
ance with legal regulations.
6. Insert a new filter bag into the
cleaned tank as described in
the instructions enclosed.
IMPORTANT:
Press the filter bag connection
firmly on to the inlet fitting.
7.2.2 Replacing the filter bag
1. Open the retaining clamps
and remove the upper sec-
tion of the cleaner from the
dirt tank.
2. Carefully remove the filter
bag connection from the inlet
fitting.
3. Close the filter bag connec-
tion with the slide.
4. Dispose of the filter bag in
accordance with legal regu-
lations.
5. Place a new filter bag into the
cleaned tank as described in
the instructions (printed on
the filter bag).
During the following work, en-
sure that dust is not unnecessarily
spread around. Wear a P2 breath-
ing mask.
7 Maintenance
7.1 Maintenance plan
After finishing work As required
7.2.1 Replacing the waste bag
7.2.2 Replacing the filter bag
7.2.3 Replacing filter element
7.2.4 Emptying dirt tank after picking up liquids
Clean the filter element before re-
placing the waste bag - see section
4.5.
During the following work, en-
sure that dust is not unnecessarily
spread around. Wear a P2 breath-
ing mask.
IMPORTANT:
Press the filter bag connection
on the inlet fitting as far as pos-
sible.
To Next Page
Loading...
Need help?
General
