Switch action
To
start the tool, simply pull the trigger.
Release
the trigger
to
stop.
CAUTION
:
Before plugging in the tool, always check
to
see
that the trigger switch actuates pro-
perly and returns to the
"OFF"
position
when released.
Operation
Grasp the rear handle with your right hand,
the front grip with your
left.
Set
the base
plate on the workpiece to be cut without
the blade making any contact. Then turn
the tool on and wait until the blade attains
full speed. Now simply move the tool for-
ward over the workpiece surface, keeping
it
flat and advancing smoothly until the
sawing
is
completed.
To
get
clean cuts,
keep your sawing line straight and your
speed of advance uniform.
Guide rule
The handy guide rule allows you to do
extra-accurate straight cuts. Simply slide
the guide rule up snugly against the side
of the workpiece and secure
it
in position
with the wing bolt on the front of the base.
It
also makes repeated cuts of uniform
workpiece width possible, too.
Trigger
switch
-
Fie.
1!
Fig.
16
10
To Next Page
Loading...
Need help?
General
