2
ENGLISH (Original instructions)
SPECIFICATIONS
Model BJR181 BJR182
Length of stroke 28 mm
Strokes per minute(min
-1
) 0 - 2,900
Pipe 130 mm
Max. cutting capacities
Wood 255 mm
Overall length 499 mm 449 mm
Net weight 3.7 kg 3.6 kg
Rated voltage D.C. 18 V
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
END004-4
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ Only for EU countries
Do not dispose of electric equipment or
battery pack together with household
waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment, 2006/66/EC on
batteries and accumulators and waste
batteries and accumulators and their
implementation in accordance with
national laws, electric equipment and
battery pack that have reached the end
of their life must be collected separately
and returned to an environmentally
compatible recycling facility.
ENE020-1
Intended use
The tool is intended for sawing wood, plastic and ferrous
materials.
ENG905-1
Noise
The typical A-weighted noise level determined according
to EN60745:
Model BJR181
Sound pressure level (L
pA
) : 84 dB(A)
Sound power level (L
WA
) : 95 dB(A)
Uncertainty (K) : 3 dB(A)
Model BJR182
Sound pressure level (L
pA
) : 85 dB(A)
Sound power level (L
WA
) : 96 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG900-1
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Model BJR181
Work mode : cutting boards
Vibration emission (a
h,CW
) : 18.5 m/s
2
Uncertainty (K) : 2.0 m/s
2
Model BJR182
Work mode : cutting boards
Vibration emission (a
h,CW
) : 19.5 m/s
2
Uncertainty (K) : 2.0 m/s
2
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
Cd
Ni-MH
Li-ion
To Next Page
Loading...
Need help?
General
