Makita BO4556 User Manual

7 ENGLISH
Removethepaperlterbagrstbypinchingthelogo
side of its cardboard lip, then by pulling the cardboard
lipdownwardstomoveitoutoftheholdingtabofthe
dust box.
OPERATION
Sanding operation
CAUTION:
• Neverrunthetoolwithouttheabrasivepaper.
You may seriously damage the pad.
• Neverforcethetool.Excessivepressuremay
decreasethesandingefciency,damagethe
abrasivepaperand/orshortentoollife.
Holdthetoolrmly.Turnthetoolonandwaituntilit
attains full speed. Then gently place the tool on the
workpiecesurface.Anishingsanderisgenerallyused
toremoveonlyasmallamountofmaterialatatime.
Since the quality of the surface is more important than
theamountofstockremoved,donotbeardownonthe
tool.Keepthebaseushwiththeworkpieceatalltimes.
MAINTENANCE
CAUTION:
• Alwaysbesurethatthetoolisswitchedoffand
unplugged before attempting to perform inspec-
tion or maintenance.
• Neverusegasoline,benzine,thinner,alcohol
or the like. Discoloration, deformation or cracks
may result.
To maintain product SAFETY and RELIABILITY,
repairs, carbon brush inspection and replacement, any
othermaintenanceoradjustmentshouldbeperformed
byMakitaAuthorizedServiceCenters,alwaysusing
Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• Theseaccessoriesorattachmentsarerecom-
mendedforusewithyourMakitatoolspecied
in this manual. The use of any other accessories
orattachmentsmightpresentariskofinjuryto
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ingtheseaccessories,askyourlocalMakitaService
Center.
• Abrasivepaper(withoutpre-punchedholes)
• Paperdustbag
• Paperdustbagholder
• Punchplate
• Dustbag
• Dustbox
• Paperlterbag
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.

Makita BO4556 Specifications

General

Power	200 W
Type of sander	Orbital sander
Cable length	2 m
Power source	AC
AC input voltage	230 V
Eccentricity	0.75 mm
Oscillating orbit diameter	1.5 mm
Idle oscillation rate (max)	14000 OPM

Weight and Dimensions

Depth	131 mm
Width	112 mm
Height	141 mm
Weight	1100 g
Sanding plate size (WxD)	112 x 102 mm