Makita DF001D User Manual

5 ENGLISH
ConnecttheUSBcabletotheACadapter,andthen
plugtheACadapterintothemainssupply.Openthe
connectorcoveronthetool,andthenconnecttheUSB
cable to the connector.
Beforetherstuse,besuretochargethebuilt-inbat-
tery.Ittakesapproximately3to5hourstofullycharge
thebattery.Thechargingtimevariesdependingonthe
usageconditionsandremainingbatterycapacity.
UnplugtheUSBcablefromthetool,andthenclosethe
connector cover.
NOTE:Whilecharging,thebuilt-inbatteryandAC
adaptermaybecomewarm.Thisisnormalandwill
continueuntilthebuilt-inbatteryisfullychargedand
theACadapterhasbeendisconnectedfromthe
mainssupply.
Tool / battery protection system
Thetoolisequippedwithatool/batteryprotection
system.Thissystemautomaticallycutsoffpowerto
themotortoextendtoolandbatterylife.Thetoolwill
automaticallystopduringoperationifthetoolisplaced
underoneofthefollowingconditions:
Overheat protection
Whenthetoolisoverheated,thetoolstopsautomati-
cally.Inthissituation,letthetoolcoolbeforeturningthe
tool on again.
Overdischarge protection
Whenthebatterycapacityisnotenough,thetoolstops
automatically.Inthiscase,chargethebattery.
Switch action
A
B
Tostartthetool,simplypushtheswitchontheAside
for the clockwise rotation and the B side for the counter-
clockwise rotation. Release the switch to stop.
CAUTION: Always check the direction of
rotation before operation.
NOTICE: Change the direction only after the tool
comes to a complete stop. Changing the direction
ofrotationbeforethetoolstopsmaydamagethetool.
Lighting up the front lamp
CAUTION: Do not look in the light or see the
source of light directly.
Toturnonthelight,pressthelampswitch.Toturnoff
thelight,pressthelampswitchagain.
ASSEMBLY
Installing or removing driver bit
Toinstalladriverbit,pushitrmlyintothedriverbit
holder.Toremovethedriverbit,pullitoutofthedriver
bit holder.

Makita DF001D Specifications

General

Product color	Black, Blue
Built-in light	Yes
Power source	Battery
Charging time	5 h
Battery voltage	3.6 V
Battery capacity	1.5 Ah
Idle speed (max)	220 RPM
Screw diameter (max)	- mm
Maximum torque (hard applications)	4 N⋅m
Maximum torque (soft applications)	3 N⋅m
Number of bits	81 pc(s)

Weight and Dimensions

Depth	287 mm
Width	47 mm
Height	51 mm
Weight	360 g