11 ENGLISH
the sleeve as far as
it will go.
Then release the sleeve to
secure the driver bit. ►
Fig.10: 1. Driver bit 2.
Sleeve
To remove the driver bit,
pull the sleeve in the
direction of the arrow and
pull the driver bit out.
NOTE: If the driver bit
is not inserted deep
enough into the sleeve, the sleeve will
not return to its original position and the
driver bit will not
be secured. In this
case, try re-inserting the
bit according to the
instructions above.
NOTE: After inserting the driver
bit, make sure that
it is firmly
secured. If it comes
out, do not use
it.
CAUTION: When installing the hook, always
secure it with the screw firmly. If not, the hook
may come off from the
tool and result in
the personal injury.
► Fig.11: 1. Groove 2. Hook 3. Screw
The hook is convenient for
temporarily hanging the tool. This
can be installed on either
side of the tool. To
install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing driver bit holder
Optional accessory ►
Fig.12: 1. Driver bit
holder 2. Driver bit
Fit the driver bit holder
into the protrusion at the
tool foot on either right or left side and
secure it with a screw. When not using
the driver bit, keep it
in the driver bit holders.
Driver bits 45 mm-long can
be kept there.
OPERATION
CAUTION: Always insert the battery cartridge
all the way until it locks in place. If
you can see the
red indicator on the
upper side of the
button, it is not
locked completely. Insert it
fully until the red
indicator cannot be seen.
If not, it may
accidentally fall out
of the tool,
causing injury to you
or someone around you.
CAUTION: When the speed comes down
extremely, reduce the load or stop the tool to
avoid the tool damage.
Hold the tool firmly with
one hand on the grip
and the other hand on
the bottom of the
battery cartridge to control the
twisting action. ► Fig.13
Screwdriving operation
CAUTION: Adjust the adjusting ring to the
proper torque level for your work.
CAUTION: Make sure that the driver bit is
inserted straight in the screw head, or the screw
and/or driver bit may be damaged.
Place the point of the
driver bit in the screw
head and apply pressure to
the tool. Start the tool
slowly and then increase the
speed gradually. Release the switch
trigger as soon as the clutch cuts in.
NOTE: When driving wood screw, pre-drill a pilot
hole 2/3 the diameter of the
screw. It makes driving
easier and prevents splitting of the
workpiece.
First, turn the adjusting ring
so that the arrow points
to the marking. Then proceed as follows.
Drilling in wood
When drilling in wood, the
best results are obtained with
wood drills equipped with a guide screw. The guide
screw makes drilling easier by
pulling the drill bit into
the workpiece.
To Next Page
Loading...
Need help?
General
