Makita DHP453 User Manual

9 ENGLISH
Adjusting the fastening torque
8
6
10
2
1
3
4
Fig.7
►1. Action mode changing ring 2.Adjustingring
3. Graduation 4. Arrow
Thefasteningtorquecanbeadjustedin16levelsby
turningtheadjustingring.Alignthegraduationswiththe
arrow on the tool body. You can get the minimum fas-
tening torque at 1 and maximum torque at 16.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to deter-
mine which torque level is required for a particular
application.
ASSEMBLY
CAUTION: Always be sure that the tool is
switched o󰀨 and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
drill bit
Optional accessory
1
Fig.8
►1. Sleeve
Turn the sleeve counterclockwise to open the chuck
jaws.Placethedriverbit/drillbitinthechuckasfar
as it will go. Turn the sleeve clockwise to tighten the
chuck. To remove the driver bit/drill bit, turn the sleeve
counterclockwise.
Installing hook
Optional accessory
WARNING: Use the hanging/mounting parts
for their intended purposes only, e.g., hanging the
tool on a tool belt between jobs or work intervals.
WARNING: Be careful not to overload the hook
as too much force or irregular overburden may cause
damages to the tool resulting in personal injury.
CAUTION: When installing the hook, always
secure it with the screw rmly. If not, the hook may
comeo󰀨fromthetoolandresultinthepersonalinjury.
CAUTION: Make sure to hang the tool securely
before releasing your hold.Insu󰀩cientorunbalanced
hookingmaycausefallingo󰀨andyoumaybeinjured.
3
1
2
Fig.9
►1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool. This can
be installed on either side of the tool. To install the hook, insert it
into a groove in the tool housing on either side and then secure it
with a screw. To remove, loosen the screw and then take it out.
Using hole
WARNING: Never use the hanging hole for
unintended purpose, for instance, tethering the
tool at high location. Bearing stress in a heavily
loaded hole may cause damages to the hole, result-
ingininjuriestoyouorpeoplearoundorbelowyou.
1
Fig.10
►1. Hanging hole
Use the hanging hole at the bottom rear of the tool to hang
the tool on a wall using a hanging cord or similar strings.

Makita DHP453 Specifications

General

Torque (max)	42 N⋅m
Number of gears	1
Torque settings	16
Screw diameter (max)	36 mm
Idle speed (1st gear)	1300 RPM
Impact rate (low speed)	6000 bpm
Impact rate (high speed)	19500 bpm
Drilling diameter in concrete (max)	13 mm
Reverse	Yes
Chuck type	Keyless
Product color	Black, Green
Power source	Battery
Battery voltage	18 V
Battery included	No

Weight and Dimensions

Weight	1700 g