Makita DJV184RFJ User Manual

10 ENGLISH
1
2
3
Fig.8
►1. Jig saw blade holder 2. Jig saw blade 3. Roller
CAUTION: If the blade clamp lever does not
move to the xed position, the jig saw blade is
not installed completely. Do not press the blade
clamp lever by hand to the xed position. It may
damage the tool.
Toremovethejigsawblade,pushthebladeclamplever
forwardasfarasitwillgo.Thisallowsthejigsawblade
to be released.
1
2
3
Fig.9
►1. Jig saw blade holder 2. Blade clamp lever 3. Jig
saw blade
NOTE:Incasethatitisdi󰀩culttoremovethejigsaw
blade:
Turn the cutting action changing lever to the position
"III"andmovethejigsawbladeholdertothebottom
before pushing the blade clamp lever to the released
position.Tomovethejigsawbladeholdertothe
bottom,returnthebladeclampleverfullytothexed
position once and slightly switch on the tool several
times.
NOTE: Occasionally lubricate the roller.
Hex wrench storage
When not in use, store the hex wrench as shown in the
guretokeepitfrombeinglost.
1
Fig.10
►1. Hex wrench
OPERATION
CAUTION: Always hold the base ush with
the workpiece.Failuretodosomaycausejigsaw
bladebreakage,resultinginaseriousinjury.
CAUTION: Advance the tool very slowly when
cutting curves or scrolling. Forcing the tool may
causeaslantedcuttingsurfaceandjigsawblade
breakage.
2
1
Fig.11
►1. Cutting line 2. Base
Turnthetoolonwithoutthejigsawblademakingany
contact and wait until the blade attains full speed. Then
restthebaseatontheworkpieceandgentlymovethe
tool forward along the previously marked cutting line.

Makita DJV184RFJ Specifications

General

Brand	Makita
Model	DJV184RFJ
Category	Cordless Saw
Language	English