Checking the chain brake
The chain brake must be checked before every use of
the saw!
Start the engine as described above (have a secure footing,
place the chain saw on the ground so that the chain and guide
bar are not near anything).
Hold the front handle rmly, with your other hand on the rear
grip.
Let the engine run at medium speed and push the handguard
(6) in the direction of the arrow using the back of your hand,
until the chain brake engages. The chain should now stop
immediately.
Bring the engine back to idle and release the chain brake.
Caution: If the chain does not stop immediately in this
test, turn o the engine immediately. Do NOT use the
chain saw in this condition! Contact a MAKITA autho-
rized service center.
To Next Page
Need help?
General
