To Next PageTo Next Page
Need help?Do you have a question about the Makita GA4590 and is the answer not in the manual?
The tool is intended for grinding, sanding, wire brushing, hole cutting and cutting of metal and stone materials without the use of water.
The tool should be connected only to a power supply of the same voltage as indicated on the nameplate.
Vibration total value determined according to EN62841-2-3 for surface grinding with normal side grip.
Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow may result in electric shock, fire and/or serious injury.
Safety warnings common for grinding, sanding, wire brushing, or cutting-off operations.
Turn the tool on and then apply the wheel or disc to the workpiece. Keep the edge of the wheel or disc at an angle of about 15° to the workpiece surface.
Do not 'jam' the wheel or apply excessive pressure. Do not start the cutting operation in the workpiece.
The tool is intended for grinding, sanding, wire brushing, hole cutting and cutting of metal and stone materials without the use of water.
The tool should be connected only to a power supply of the same voltage as indicated on the nameplate.
Vibration total value determined according to EN62841-2-3 for surface grinding with normal side grip.
Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow may result in electric shock, fire and/or serious injury.
Safety warnings common for grinding, sanding, wire brushing, or cutting-off operations.
Turn the tool on and then apply the wheel or disc to the workpiece. Keep the edge of the wheel or disc at an angle of about 15° to the workpiece surface.
Do not 'jam' the wheel or apply excessive pressure. Do not start the cutting operation in the workpiece.
General| Power Source | Electric |
|---|---|
| Voltage | 120V |
| Weight | 5.5 lbs |
| Wheel Diameter | 115mm |
| No Load Speed | 11, 000 RPM |
| Arbor | 5/8 inches |
| Spindle Thread | 5/8" x 11 UNC |
| Length | 305mm |
