Makita HG651C User Manual

English - 9 -
Observe the mains voltage: The voltage of the power source must agree with the value given on the name-
plate of the unit. Extension cords must have a conductor cross section of 2 x 1.5 mm
2
min.
Switching On:
: Set the switch 1 to I or II.
: Set the switch 1 to I or II. Set the temperature
controller 2 as required.
: Set the switch 1 to I. Select the desired pro-
gram or program the temperature and air flow
as required (see “Settings”).
Switching Off:
Set the switch 1 to 0.
To cool the unit off, set the switch 1 to II and the tem-
perature controller 2 to MIN. When the unit has
cooled off, set the switch 1 to 0.
To cool off the unit, have it operate on COOL
DOWN (see “Settings”).
When the unit has cooled off, set the switch 1 to 0.
Begin the selection with the SELECT pushbutton (menu). Note: When an indication flashes in the display, a
change can be initiated with either PLUS or MINUS. Repeated actuation of SELECT leads to the next step.
Language selection, temperatur
Selecting the function program
The keyword of the selected function program is indicated by flashing. Longer text begins to move after 2 sec-
onds and returns to the keyword after 2 passes. Within this period, the SELECT pushbutton can be pressed
again to adjust the temperature or the air flow.
Selecting STANDBY or COOL DOWN
– Select STANDBY when interrupting your work for short time. The energy absorption is reduced.
– At the end of your work, always select COOL DOWN. When the unit has cooled off, switch it off and pull
the plug from the receptacle.
Putting into Operation
A
B
C
Adjusting the Settings on the Display 2
C
ENGLISH
PORTUGUES
M
E
N
U
S
E
L
E
C
T
2 sec 1 x
M
E
N
U
S
E
L
E
C
T
1 x
M
E
N
U
S
E
L
E
C
T
1 x
M
E
N
U
S
E
L
E
C
T
CELSIUS
FAHRENHEIT
SAVE
RESET
1. 1-Free setting 80 °C/5 8. Welding PPEPDM 280 °C/5
2. 2-Free setting 80 °C/5 9. Welding HD-PE 300 °C/3
3. Shrinking 450 °C/5 10. Welding PP 320 °C/3
4. Forming 500 °C/4 11. Welding PVC-U 340 °C/3
5. Soldering copper 650 °C/3 12. Welding ABS 360 °C/3
6. Drying paint 650 °C/5 13. Welding PC 370 °C/3
7. Paint stripping 425 °C/5 14. Welding floor-foil 450 °C/3
1-FREE
WELDING
M
E
N
U
S
E
L
E
C
T
1 x 1 x
M
E
N
U
S
E
L
E
C
T
1 x
M
E
N
U
S
E
L
E
C
T
M
E
N
U
S
E
L
E
C
T
COOL DOWN STAND-BY
S
T
A
N
D
B
Y
S
T
A
N
D
B
Y
WELDY.book Seite 9 Mittwoch, 17. Mai 2006 1:02 13

Makita HG651C Specifications

General

Brand	Makita
Model	HG651C
Category	Power Tool
Language	English