Makita HR4013C User Manual

5
Speed change
1
014029
The revolutions and blows per minute can be adjusted
just by turning the adjusting dial. The dial is marked 1
(lowest speed) to 5 (full speed).
Refer to the table below for the relationship between the
number settings on the adjusting dial and the
revolutions/blows per minute.
For Model HR4003C, HR4013C
Number on
adjusting dial
Revolutions per
minute
Blows per minute
5 500 2,900
4 470 2,700
3 380 2,150
2 290 1,650
1 250 1,450
014134
For Model HR5202C, HR5212C
Number on
adjusting dial
Revolutions per
minute
Blows per minute
5 310 2,250
4 290 2,100
3 230 1,700
2 180 1,300
1 150 1,100
014872
For model HR4013C, HR5212C only
NOTE:
• Blows at no load per minute becomes smaller than
those on load in order to reduce vibration under no
load, but this does not show trouble. Once
operation starts with a bit against concrete, blows
per minute increase and get to the numbers as
shown in the table. When temperature is low and
there is less fluidity in grease, the tool may not
have this function even with the motor rotating.
CAUTION:
• If the tool is operated continuously at low speeds
for a long time, the motor may get overloaded,
resulting in tool malfunction.
• The speed adjusting dial can be turned only as far
as 5 and back to 1. Do not force it past 5 or 1, or
the speed adjusting function may no longer work.
Selecting the action mode
CAUTION:
• Do not rotate the change lever when the tool is
running. The tool will be damaged.
• To avoid rapid wear on the mode change
mechanism, be sure that the change lever is
always positively located in one of the action mode
positions.
Hammer drilling mode
1
2
014022
For drilling in concrete, masonry, etc., rotate the change
lever to the
symbol. Use a tungsten-carbide tipped bit.
Hammering mode (Switch trigger mode)
1
2
014024
For chipping, scaling or demolition operations, rotate the
change lever to the
symbol. Use a bull point, cold
chisel, scaling chisel, etc.
Hammering mode (Switch button mode)
2
1
014023
For continuous chipping, scaling or demolition
operations, rotate the change lever to the
symbol.
1. Change lever
2. Pointer
1. Change lever
2. Pointer
1. Change lever
2. Pointer
1. Adjusting dial

Makita HR4013C Specifications

General

Chuck type	SDS Max
Product color	Black, Blue
Adjustable speed	Yes
Cord length	4 m
Input power	1100 W
Power source	AC
AC input voltage	110-240 V
Impact rate	2900 bpm
Rated speed (max)	500 RPM
Impact energy (max)	8.3 J
Sound pressure level	92 dB
Drilling diameter in steel (max)	- mm
Drilling diameter in concrete (max)	40 mm

Weight and Dimensions

Depth	479 mm
Width	112 mm
Height	263 mm
Weight	6800 g