Makita JR3051T User Manual

6 ENGLISH
2. Insert the square nuts into the tool as shown in the
gure.
3. Secure the hook with the screws.
1
2
3
► 1. Square nut 2. Hook 3. Screw
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing or removing the recipro
saw blade
CAUTION: Always clean out all chips or for-
eign matter adhering to the blade and around the
blade clamp. Failure to do so may cause insufcient
tightening of the blade, resulting in a serious injury.
Before installing the recipro saw blade, always make
sure that the blade clamp lever (part of the blade clamp
sleeve) is in released position on the insulation
cover. If the blade clamp lever is in xed position, rotate
the blade clamp lever in the direction of the arrow so
that it can be locked at the released position .
1
2
3
► 1. Blade clamp lever 2. Released position 3. Fixed
position
Insert the recipro saw blade into the blade clamp as far
as it will go. The blade clamp sleeve rotates and xes
the recipro saw blade. Make sure that the recipro saw
blade cannot be extracted even though you try to pull
it out.
1
2
► 1. Recipro saw blade 2. Blade clamp sleeve
CAUTION: If you do not insert the recipro saw
blade deep enough, the recipro saw blade may be
ejected unexpectedly during operation. This can
be extremely dangerous.
To remove the recipro saw blade, rotate the blade
clamp lever in the direction of the arrow fully. The reci-
pro saw blade is removed and the blade clamp lever is
xed at the released position .
1
2
► 1. Recipro saw blade 2. Blade clamp lever
CAUTION: Keep hands and ngers away from
the lever during the switching operation. Failure
to do so may cause personal injuries.
NOTE: If you remove the recipro saw blade without
rotating the blade clamp lever fully, the lever may not
be locked in the released position . In this case,
rotate the blade clamp lever fully again, then make
sure that the blade clamp lever locked at the released
position .
NOTE: If the blade clamp lever is positioned inside
the tool, switch on the tool just a second to let the
blade out. Unplug the tool before installing or remov-
ing the recipro saw blade.

Makita JR3051T Specifications

General

Brand	Makita
Model	JR3051T
Category	Saw
Language	English