ML180
Voltage Battery cartridge Operating time Charger
18 V
1822 Approx. 190 min.
DC1801
1833 Approx. 220 min.
1834 Approx. 260 min.
1835 Approx. 300 min.
Storing battery cartridge
Always charge the Nickel Metal Hydride battery car-
tridge before storing it when you do not use it for more
than six months.
Head angle (Fig. 3)
The head angle can be adjusted in four stages. Adjust
as desired.
Replacing bulb (Fig.4&5)
CAUTION:
The bulb is very hot immediately after operation. Wait
until the bulb cools off before attempting to replace it.
First, turn the ring counterclockwise and remove the
reflector. Then replace the bulb.
Shoulder strap (Fig. 6)
Install the strap on the tool.
MAINTENANCE
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
ACCESSORIES
CAUTION:
These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments
might present a risk of injury to persons. The acces-
sories or attachments should be used only in the
proper and intended manner.
•
Bulb set (2 pcs)
•
Shoulder strap
•
Setplate(ForModelML120)
6
To Next Page
Loading...
Need help?
General
