14 ENGLISH
5. Place the cover onto the tool and tighten the hex
socket bolts using the hex wrench.
1
3
2
► 1. Tube 2. Cover 3. Hex socket bolt
NOTICE: Make sure that the tube for water feed
is in the positions as shown in the gure before
attaching the cover.
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection rst. If you nd a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-
ment parts for repairs.
State of abnormality Probable cause (malfunction) Remedy
Motor does not run. Battery cartridges are not installed. Install two battery cartridges. This tool does not
work with one battery cartridge.
Battery problem (under voltage) Recharge the battery. If recharging is not eective,
replace the battery cartridge.
The drive system does not work
correctly.
Ask your local authorized service center for repair.
Motor stops running after a little use. Battery's charge level is low. Recharge the battery. If recharging is not eective,
replace the battery cartridge.
Overheating. Stop using of tool to allow it to cool down.
The wheel rotation does not acceler-
ate properly even after running the
tool without load for 20 seconds.
Battery is installed improperly. Install the battery cartridge as described in this
manual.
Battery power is dropping. Recharge the battery cartridge. If recharging is not
eective, replace the battery cartridge.
The V-belt is slipping. Replace the V-belt with new one.
The drive system does not work
correctly.
Ask your local authorized service center for repair.
Wheel does not rotate:
stop the machine immediately!
The V-belt is slipping. Replace the V-belt with new one.
Foreign object is jammed between the
guard and the wheel.
Uninstall the battery cartridge and then remove the
foreign object.
The drive system does not work
correctly.
Ask your local authorized service center for repair.
To Next Page
Loading...
Need help?
General
