To Next PageTo Next PageWhat to do if my Makita XGT 40 V Max Blower motor stops after a short time?
If the motor stops running after a short period, it could be due to: * Low battery charge: Recharge the battery, and if that doesn't work, replace it. * Overheating: Stop using the blower to allow it to cool down.
What to do if Makita XGT 40 V Max motor cannot stop?
If the motor cannot stop, it indicates an electric or electronic malfunction. Remove the battery and ask your local authorized service center for repair.
Why won't my Makita Blower motor run?
The motor might not be running due to several reasons: * The battery may not be installed. If this is the case, install the battery. * There could be a battery problem, such as undervoltage. Try recharging the battery. If recharging isn't effective, replace it. * The drive system may not be working correctly. In this case, you should ask your local authorized service center for repair.
Why doesn't my Makita XGT 40 V Max Blower reach maximum speed?
If your machine isn't reaching its maximum speed, it could be due to a few reasons: * The battery might be installed improperly. Make sure to install the battery as described in the manual. * The battery power could be dropping. Try recharging the battery, and if that doesn't work, replace it. * The drive system may not be functioning correctly. In this instance, consult your local authorized service center for repair.
How to fix a Makita XGT 40 V Max when mist is not discharged?
If mist is not being discharged from your Makita Blower, consider these possibilities: * The tank could be empty. Fill the tank with liquid. * The nozzle lever or tank lever might be closed. Open both the nozzle lever and the tank lever. * The nozzle could be clogged. Remove the standard nozzle or ULV nozzle, then clean it with running water to remove any blockage. * The filter might be clogged. Remove the filter and clean it with running water to eliminate any obstructions.
What causes abnormal vibration in a Makita XGT 40 V Max?
If you're experiencing abnormal vibration, it's likely that the drive system isn't working correctly. You should ask your local authorized service center for repair.
Adjust the length of the shoulder harness and waist belt for proper fit.
Move the control handle along the swivel pipe for comfortable operation.
Attach the diffusion cover to the end nozzle to diffuse the mist.
Attach the deflector to the end nozzle for directional mist discharge.
Procedure for safely installing and removing the battery cartridge from the machine.
Machine stops if current draw is abnormally high, main power lamp blinks green.
Machine stops if overheated, main power lamp lights up red.
Machine stops if battery capacity is low, main power lamp blinks red.
System stops machine for other causes like temporary halt or stop in operation.
Adjust the length of the shoulder harness and waist belt for proper fit.
Move the control handle along the swivel pipe for comfortable operation.
Attach the diffusion cover to the end nozzle to diffuse the mist.
Attach the deflector to the end nozzle for directional mist discharge.
Procedure for safely installing and removing the battery cartridge from the machine.
Machine stops if current draw is abnormally high, main power lamp blinks green.
Machine stops if overheated, main power lamp lights up red.
Machine stops if battery capacity is low, main power lamp blinks red.
System stops machine for other causes like temporary halt or stop in operation.
General
